How do you fix a GameCube that wont read discs?
The Disc could not be read:
- Ensure the game is inserted correctly. With the power turned off on the system, replace the Game Disc in the system, printed side up.
- Determine if this happens with more than one game by inserting a different game into the system.
What screwdriver do I need to open a Gamecube?
Steel 4.5mm Screwdriver Security Bit Open SNES N64 GameCube Game Consoles + Genesis Master System Games.
How many ohms is a GameCube laser?
The factory settings of the potentiometer varied from DOL-001 with a value range of 450 ohm – 600 ohm while the DOL-101 had a value range of 150 ohm – 250 ohm. Some lasers require adjustment to eliminate DRE or to read DVD+/-R.
How do you calibrate a GameCube?
Recalibrate the Controller in one of the following ways:
- Push RESET (or turn the system OFF and then ON) while making sure to not touch the control stick.
- Press the X, Y, and Start/Pause buttons simultaneously for three seconds during game play, making sure to not touch the control stick.
Why does my GameCube stop spinning the disc?
If the drive detects no disc, it won’t spin the motor. So if your laser is dying, and it cant see anything, it wont spin the disc.
Can you buff GameCube games?
Can you buff GameCube games? Deeper scratches on the top of the disc make the disc almost impossible to repair. Data can not be retrieved from a disc that has been damaged hard on the top side. However, scratches on the bottom are repairable by polishing.
Do scratched Gamecube games work?
If it’s dirty, scratched, or shows no obvious damage You may try cleaning the disc again with a soft, slightly damp cotton cloth (use water only). Clean the disc from center towards the edges; do not use a circular motion. DO NOT use paper. Make sure the game is dry, then re-insert it and see if the error occurs again.
What tools do you need to take apart a Gamecube?
Tools Featured in this Teardown
- Gamebit 4.5mm. $24.99.
- Phillips #00 Screwdriver.
- Spudger.
Can you replace the laser on a GameCube?
This GameCube optical laser drive replacement will replace your OEM laser reader to repair your Nintendo GameCube. In stock! Usually ships within 24 hours.
How do you remove the optical drive on a GameCube?
The optical drive is secured to a metal plate. Using a Phillips #2 screwdriver, unscrew the twelve (12) screws that are around the outer edge of the optical drive (circled in red). Carefully separate the optical drive assembly from the rest of the GameCube unit.
How do you remove the bottom of a GameCube?
Locate the four screws (circled in red) on each corner of the device. Then, use a 4.5 mm Gamebit screwdriver to remove all four screws. With the bottom side of the GameCube facing upward and the screws removed, carefully pull the outer shell of the unit away from the top half.
How do you fix a GameCube that wont turn on?
Turn over the Gamecube so that the bottom side is facing up. Locate the four screws (circled in red) on each corner of the device. Then, use a 4.5 mm Gamebit screwdriver to remove all four screws.
How do I change the orientation of my GameCube?
With the bottom side of the GameCube facing upward and the screws removed, carefully pull the outer shell of the unit away from the top half. Then place the inside of the unit facing up.