How do you start a 6.0 Powerstroke after running out of fuel?

Prime the fuel system by turning the ignition on (Run position) for 30 seconds, but do not start the engine. This allows the pump to prime the system. Turn the ignition off, and then crank it for 15 seconds. If it does not start, repeat the first task and this one until it starts (cycle the key).

Table of Contents

How do you know if your fuel pump is bad on a 6.0 Powerstroke?

Is My Fuel Pump Going Bad? Here Are 8 Signs It Is!

Fuel Tank Noise. A damaged fuel pump might make a loud, whining sound that you’ll hear from your gas tank.
Difficult Starts.
Sputtering Engine.
The Actual Stall.
Power Loss.
Surging Power.
Lower Fuel Efficiency.
Dead Engine.

Does a 6.0 Powerstroke have a lift pump?

Now, with the addition of a diesel lift pump system for 03-07 6.0L Powerstrokes, these owners can also reap the benefits of the system, including resolving the ¼ issue, the pressure control issue, and motor shaft seal failures.

What fuel pump is in a 6.0 Powerstroke?

Compare with similar items

	This item Motorcraft – Pump Assy – Fuel (P) (PFB101)	iFJF PFB-101 HFCM Fuel Pump and Filter Assembly Replacement for F250 F350 F450 F550 Super Duty 6.0L V8 2003-2007 Excursion 2003-2005 Powerstroke Diesel Engine 6C3Z-9G282-C 6C3Z9F759A
Item Weight	4.85 lbs	4.90 lbs
Material	Metal	Aluminum
Style	Piston	—

How do you prime a fuel pump?

Priming the Fuel System

Fill the fuel tank.
Turn the ignition key to the ON position.
Move the engine stop/run switch to the RUN position.
Allow the fuel pump to run until it stops (about 2 seconds).
Move the engine stop/run switch to the STOP position.
Repeat steps 3–5 four to five times.

What happens if you run a diesel empty?

When you run low on diesel, your fuel pump might send air through your fuel system instead of gas. If that happens, your vehicle will shut down and not restart until the air is removed. This is called “bleeding” the fuel system, and depending on your machine, it can take several hours to complete.